Trusculpt 3D Fat Reduction
What is truSculpt 3D Fat Reduction?
Fat Loss Reduction treatment for hard-to-tone areas of the body
truSculpt 3D is a non-invasive fat reduction treatment that uses Monopolar Radio Frequency (RF) to sculpt and contour the body. truSculpt 3D takes a multi-dimensional approach to decreasing circumference in stubborn areas around the abdomen and flanks by targeting and heating fat cells. The fat cells are then slowly removed and excreted through the body naturally.
Cutera, makers of truSculpt 3D, reports an average body fat reduction of 24% from a single 60-minute session.
Why choose truSculpt 3D over Coolsculpting?
TruSculpt 3D and CoolSculpting are both non-invasive fat reduction treatments. While Coolsculpting uses cold or cryolipolysis to get rid of fat, truSculpt 3D uses Monopolar Radio Frequency heat.
truSculpt 3D can treat all areas of the body unlike Coolsculpting which requires the area to be “pinchable”. In addition, truSculpt 3D tightens skin and improves skin texture during the treatment.
What areas can truSculpt 3D treat?
truSculpt 3D is FDA-approved for the abdomen and flanks (love handles), but truSculpt 3D is also safe to use on the arms, upper back (bra bulges), chin and other body areas.
The duration of each procedure depends on the area being treated. But the most common treatment area, abdomen and flanks, takes approximately 1 hour.
What can I expect during my visit?
truSculpt 3D’s patented hand piece glides over the treatment area side-to-side to deliver uniform heat that penetrates the entire fat layer. The procedure feels like a hot stone massage but the design of the hand piece eliminates potential hotspots and ensures patient safety and comfort.
How many treatments are required for best results?
Ideal candidates typically have a BMI of less than 30 and ideally have less than 30 pounds to lose to reach their ideal weight. With these patients, results are visible after one treatment, although some patients opt for a second or third session.
What is the downtime?
There is no downtime with truSculpt 3D’s non-invasive procedure so you will be able to resume your normal activities right after the treatment. You may feel some tenderness in the area right after treatment but that will go away within a day or two.
Are there any alternatives to truSculpt 3D?
To dissolve unwanted fat we also offer the following treatments:
Fat dissolving injection – Mesotherapy is an injectable that contains homeopathic medications, plant extracts, vitamins and other skin supportive ingredients that improve skin circulation and assist in breaking down stored fat